Need help with trim chip
3 posters
RigidChips :: Rigid-Chips :: Tutorials :: Request a Tutorial
Page 1 of 1
Need help with trim chip
Hi I have jsut started using rigidchips and stuff tryed to make a simple plant but yaw ont work cuz i cant get the trim chip to go from -45 degrees to 90 but still be able to turn.... please help sorry for the noob problem.
power5000- Car
- Posts : 5
Join date : 2011-11-05
Re: Need help with trim chip
uhh you mean you want it to be at -45 degrees and press a button and it will go to 90 degrees? sorry i don't really understand the question can you reword it/go into more detail?
darkeye22- Tank
- Posts : 55
Join date : 2011-06-01
Location : Stuck inside RigidChips trying to find a way out
Re: Need help with trim chip
ok the chip I'm attaching the trim to is at -45 degrees i need to change it to 0 (up and down on the y axis) and rotate on the y axis. Is this possible?
power5000- Car
- Posts : 5
Join date : 2011-11-05
Re: Need help with trim chip
Ok, so if i understand you right you want it so its at a -45 degree angle you press a button and it turns to a 90 degree angle (90 degrees is up and down on the y axis) and then you want it so you can turn it on the y axis with out it being connected to the Trim? Sorry if i still don't understand you -_-
EDIT: To answer your question there is not anyway that i know of to do what you are trying to explain unless i still don't understand you >_>
EDIT: To answer your question there is not anyway that i know of to do what you are trying to explain unless i still don't understand you >_>
darkeye22- Tank
- Posts : 55
Join date : 2011-06-01
Location : Stuck inside RigidChips trying to find a way out
Re: Need help with trim chip
no i just want it to be at 90 degrees I need to change set the angle to 90 degrees so like it started there but then have it be able to change te angle with X button so like (angle=90) but for buttons it needs to be (angle= yaw)
power5000- Car
- Posts : 5
Join date : 2011-11-05
Re: Need help with trim chip
You mean you want to make a rudder to steer the plane?
darkeye22- Tank
- Posts : 55
Join date : 2011-06-01
Location : Stuck inside RigidChips trying to find a way out
Re: Need help with trim chip
Sorry for the late reply but I haven't been active on the forum for a long time.
Could you post your model so we can help you beter?
Also, have you read my tutorial about analogue controls? It might help a little.
Though it sounds like you haven't setup your "yaw" variable correctly.
Make default: 90 (how you want the starting angle to be)
Max: 135 (90 + 45)
Min: 45 (90 - 45)
Step: (around the same value as what you set in the keys-section)
Hope this helps!
Could you post your model so we can help you beter?
Also, have you read my tutorial about analogue controls? It might help a little.
Though it sounds like you haven't setup your "yaw" variable correctly.
Make default: 90 (how you want the starting angle to be)
Max: 135 (90 + 45)
Min: 45 (90 - 45)
Step: (around the same value as what you set in the keys-section)
Hope this helps!
T-Bouw- Car
- Posts : 22
Join date : 2010-07-22
Age : 40
Location : The Netherlands
RigidChips :: Rigid-Chips :: Tutorials :: Request a Tutorial
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum